In fact, it may even be an easier process for you. Note: First mark installation position. Pumps supplied as spare parts are not filled with oil. Reminds me of the definition of FaFugnuegen. Page 42-65 18 - Hex bolt, 10 Nm 7 ft lb 19 - Backing plate 20 - Parking brake cable Adjusting parking. If you enter your registration details only, do not solely rely on the results you receive and seek further information from other sources or call a Volkswagen retailer.
Note: Use vice clamps, check vice clamps for impurities e. Functional check - With engine switched off, depress brake pedal. Illustration shows the housing in cross section for better view 1 - Puller, e. Ib New belts, 7 Nm 62 in. Check for cracks and abrasion Before tightening the small clamp, ventilate boot briefly so pressure is equalized, Fig.
For a satisfactory and successful repair, the greatest care, safety and proper tools are required. Installation position: Shoulder on outer mounting to outside, to inside on inner mounting to center of vehicle. To remove the right-hand control arm inner bolt, remove brake pressure regulator from axle beam. The wheel bearing is secured by a 12-point nut. Both halves are joined to one another by spring pins arrow. Page 3 of 5 45-3 Thoroughly clean all unions and the adjacent areas before loosening, do not use aggressive cleaning agents such as brake cleaner, petrol, thinners or similar. Make sure that the centering ring wiring connection is located in the recess in the trim panel.
Splines must be free of oil and grease. This amount is subject to change until you make payment. Note: The kidney-shaped recess must be pointing in direction of travel when viewed from the center of. The splines of the outer joint and the hub on Plus suspensions are secured with locking fluid D 185 400 A2. Only use stub axles with 6 mounting holes. This rubber mounting may only be installed in the control arm inner mounting. On Diesel engines an exhauster is installed to create the required vacuum.
When removing the brake drum make sure that the outer wheel bearing does not fall out. Before installing speed sensor, clean mounting hole and coat with lubricating paste, G 000 650. New brake calipers are filled with brake fluid and are pre-bled. If you have a vehicle that is from the 2014 model year or newer, you can download the iOwn app. Tightening torque: 10 Nm 7 ft lb Fig. Make sure that the sealing ring in the housing is not damaged by the teeth of the pinion.
Illustration shows the housing in cross section for better view. If necessary pull both sections firmly apart onto stop or press together. Damaged dented grease caps allow ingress of moisture, therefore always use the illustrated tool. Welding and straightening of the axle beam is not permissible. Secure the triple-rotor joint with tape so that the housing is not inadvertently pushed back when installing the axle shaft. Ib - Tighten adjustment clamping bolt -3- to 25 Nm 18 ft lb.
Damaged dented grease caps allow ingress of moisture, therefore always use the illustrated tool. The sealing lip - arrow- points toward tool - Drive sealing ring into stop 1 - Sealing ring. Pumps supplied as spare parts are not filled with hydraulic oil. If piston is difficult to move, use a 13 mm open end wrench on flats arrow A provided for this purpose. Therefore note the following points: Install oil seal and grease cap as shown. Always obtain prices from your chosen retailer.
Removing - Before removing brake pedal remove trim - Remove brake pedal clevis pin connection securing clip. Rear axle test pressures too low: - Tension regulator spring. Continue The information continued in this publication is correct at the time to going to print. Front brake thickness Pad thickness Rear brake caliper dia. Fill the pump with G 002 000 hydraulic oil and rotate it by hand, otherwise the pump may be damaged or noisy during. Note: Hold piston in front of caliper housing.