Caliper mounting bolts 1 4. Refit the rider's seat see page 16-17. Silencer mounting bracket fixing 2. All other models will show Not Applicable in this field. Fit the right hand front bolt located at the front of the cylinder head , fit a new nut and tighten to 48 Nm.
Fixings Remove and discard the actuator pulley wheel fixing. This fuel may be used in Triumph motorcycles. Refit the seats see page 16-17. All other models will show Not Applicable in this field. Drive a new lower outer bearing into the frame headstock. Warning Label Locations - Daytona 675 Windshield Breaking-In Coolant. Dowel from the bearing housing.
Refit the sprocket cover and tighten the bolts to 9 Nm. Ensure that Nuts, bolts, fasteners: Visually the throttle grip returns to the idle check that steering and suspension position without sticking page 80. This is for the accessory Warning alarm system. Horizontal beam adjusters 1 7. Refit the rider's seat see page 16-17. Failure to observe any of the above warnings may lead to a fire hazard which could result in personal injury.
Fit the rear panel s see page 16-18 for Daytona 675 Daytona 675 only: Remove the lower fairings see or page 16-25 for Street Triple and Street Triple R. Remove the fuel tank see page 10-89. Strict observance of the so specified items will enable one to obtain the full performance of the vehicle. This is the same type of service manual your local dealer will use when doing a repair for your Acura Legend. Detach the header pipe assembly and collect the seals from the cylinder head ports. If the low oil pressure warning light stays on after starting the engine, stop engine immediately and investigate the cause.
Refit the rider's seat see page 16-17. Purge hose to throttle bodies 1 0. Hooks Assembly Assembly is the reverse of disassembly. Reconnect the battery, positive red lead first Refit the rider's seat see page 16- 17. Tighten the fixing to 7 Nm. Loss of coolant may cause the engine to overheat and suffer severe damage.
Remove and discard the fixings securing the sprag 3. Third key for alarm system For Daytona 675 there is a third key that does not have a fob. Disconnect the direction indicator and licence plate li ght electrical connectors. Tighten the pad retaining pin to 18 Nm. Refit the airbox see page 10-96. Sixth gear selector fork 3.
Standard journal Examine the camshaft and camshaft ladder for excessive wear and damage. Actuator pulley wheel fixing boss facing outwards 2. Check the radiator grille and fins for obstructions by insects, leaves or Remove the cap from the expansion mud. Refit the fuel tank see page 10-90. Refit the camshafts see page 3- 17.
Tread wear indicator 1 5. . Refit the fork see page 13-8. Continuous brake application overheat brakes reduce their effectiveness. Instruments return to normal operation.